Driving on the freeway, anything can happen. Unexpected debris comes flying from out of nowhere and hits your car windshield. Now it is another item on your to-do list that you just did not need. Waiting in the repair shop for the auto glass to be replaced or having to leave your car for a while to get it replaced are no fun. However, there are solutions. Insurance makes the experience a little more bearable.

Regardless of its' location, if the chip is a lot bigger than 3 inches than most glass company firms will tell you that you need to replace it. If the chip is smaller than that, it can usually be fixed. The important thing is that you do not get talked into replacing your windshield when it is not necessary. If you suspect that a simple front window repair job would suffice, get at least 3-5 opinions before making the final call.



Once the door panel is removed, the problem may be quite obvious, as it was in my case. Your door may have a vapor barrier or plastic sheet that is glued to the door. Carefully remove this. In most cases, you can reuse the adhesive for the barrier during re-assembly. Make sure the motor is connected. Look for burned wires or obvious damage. If everything is intact, you need to test the motor. The best way to do this is to run a jumper wire from the positive terminal of your battery to the positive side of the motor to see if it jumps to life. If not, the motor needs to be replaced.

Now open the windshield car auto glass repair kit, it contains an adhesive disc. Place it in the middle of the chip and the disc's tab must be pointing towards you. The pedestal from the kit has to be placed on the tab.

If you don't windshield chip repair hear anything at all there may be a loose corroded or broken wire somewhere in the circuit. Start at the fuse box and trace the wire to the window switch. You can do this with a voltmeter or a 12 volt test light. If you have 12 volts going into the switch, but no voltage coming out of the switch when you press the button, the switch is probably faulty. If 12 volts is coming out of the switch, then the problem is either in the wiring from the switch to the window motor or the motor itself.

The syringe cover is to be removed now and the syringe should be pressed with the repair compound into the support rod. Keep twisting till the syringe is in its position.

Once you decide that you need to fix your windshield, the best place to go is to a windshield repair professional. They have a specialized skill set that ensures that the job will be done right. Moreover, getting your windshield repaired can require special tools and techniques that are hard to find anywhere else. Windshield repair professionals focus primarily on fixing windshield problems just like yours. When it comes to something as important as your windshield, a windshield repair professional is always going to be the best option available.